[. . . ] Important Do not connect the USB cable until after the software is installed. Important If an unintended language is displayed on the LCD, proceed setup to the end of step 3 "Install the Ink Tanks", and then refer to "An Unintended Language Is Displayed on the LCD" in "Troubleshooting" of the User's Guide on-screen manual to change the LCD language. 2 Install the Print Head a Remove the Print Head from its package. 3 Install the Ink Tanks a Peel back the orange tab completely and remove the plastic wrapper from the ink tank. Loading Paper This machine offers two paper sources to load printing paper; the Auto Sheet Feeder, found at the top of the machine, and the Front Feeder, found at the front of the machine. If the message <Install the print head and set the ink tank. > appears, go to e. e Lift the Scanning Unit (Printer Cover) open, and Scanning Unit (Printer Cover) set the Scanning Unit Support to hold the cover. [. . . ] · For Windows XP or Windows 2000, log on to Windows as a member of the Administrators group before continuing. · Before installing the driver, disable all anti-virus programs and automatically loading programs. f Read the License Agreement carefully and click Yes. M ac in to sh w s Follow the on-screen instructions to install the software. If a message asking for your confirmation to restart your computer appears, click OK. The software will begin identifying the printer port being used. Important If you cannot go to the next procedure after 3 minutes, refer to "Troubleshooting" instructions in the User's Guide on-screen manual. Important Since Mac® OS 9, Mac OS X Classic environments, or Mac OS X v. 10. 2. 7 or earlier are not supported, do not connect the machine to these. · Before installing the driver, disable all anti-virus programs and automatically loading programs. g When the list of applications to install appears, confirm the contents, then click Install. Note Move the cursor over items to display explanations of each application below. g When the Printer Connection screen appears, connect the h Read the License Agreement carefully and click Yes. a Turn off the machine. (1) Press the ON/OFF button. (2) Make sure that the POWER lamp stops flashing. Follow the on-screen instructions to install the software. Note When the User Registration screen appears, follow on-screen instructions to register your product. You will need your product serial number, which is located on the inside of the machine. See Step 1- f on the front page. i Follow the on-screen instructions to register your product. b Turn the computer on and start Windows. Important If you see the Found New Hardware Wizard, remove the USB cable. Then proceed from step 3 to install the MP Drivers. a Connect one end of the USB cable to the computer, the other to the machine. Note Make sure the machine is turned on. j When the Installation completed successfully screen appears, click Restart. The system is restarted automatically. c Insert the Setup CD-ROM. The setup program should run automatically. Note The setup program should run automatically. [. . . ] "Windows" is a trademark of Microsoft Corporation, registered in the United States and other countries. "Macintosh" and "Mac" are trademarks of Apple Computer, Inc. , registered in the U. S. [. . . ]